nav-left cat-right

Understanding Areas of a New York Plantation Shutters

Plantation shutters are a lovely way to infuse your home with a feeling of luxury. One of the first steps in installing shutters is to accurately calculate the windows for which they would be used. Keep in mind whether the shutters will be placed on the inside or outside of the window frame as you go through the steps. The methods of measurement vary. It’s also crucial to remember the backspace, which will allow for louvre clearance and shutter operation. Make sure there’s enough space for hand cranks, moulding, trim, and even the shutter.Get the facts about Plantation Shutters

Each side of your window should be measured diagonally. Your window is out of square if there is a gap in the diagonal measurements. You should be fine if the difference is less than a 14th of an inch, but anything between 14 and 12 inches is considered out of square, and anything over 12 inches is considered greatly out of square. The type of frame and mount you select for your plantation shutters will be influenced by the squareness of your window.

Measure for height and trim on the inside of the drywall or trim at the points where the plantation shutters would be placed. If the drywall or trim narrows further back into the window gap, it’s necessary to think about it. If it does, you’ll want to use the narrower of the two measurements to figure out where your shutters can go. When measuring for inside mounting shutters, make sure you weigh the actual window opening and don’t subtract anything. Since the factory can make the shutters slightly smaller than the measurements you give, accuracy is crucial. You should round down to the nearest 1/16 of a decimal place “. If the measurement is between 3/16″ and 1/4″, for example, round down to 3/16″ “.